atp series push type internal tube cutter

Range 5/8" OD to 1.1/2" OD - 4.0" to 10.0" Reach

ATP Series push type internal tube cutter

Features:

POWERMASTER INDUSTRIAL “Push Type” Internal Tube Cutters quickly cuts through the walls of
ferrous tubes in Condensers and Heat Exchangers as a step in their removal from the tube sheet.

This sturdy “Push Type” Internal Tube Cutters can be used with a portable Electric or Air Drill Motor.
“Push Type” Cutters are simple to operate. Merely insert it into the tube, apply power, press inward
and the tube can be cut in a few seconds. Releasing of inward pressure automatically retracts the Cutter Bit.

These Tube Cutters are equipped with an adjustable collar suitable for reaching into tubes at various depths.
The replaceable cutting bit can be interchanged in a few seconds. Standard adjustable reach is 4”(101.6mm)
and they are available in optional increments of 2”(50.8mm).
“A” reach = 6”(152.4mm). “B” reach = 8”(203.2mm). “C” reach = 10”(254.0mm) etc.

All Tube Cutters come with a complete set of pilots covering the entire range of tube thickness for a particular tube O.D. (ATP-625 tube cutters come with a built in pilot suitable for one tube ID only.)
All Tube Cutters are available for MM tube sizes also. Please enquire.

Consult the PDF Specifications below to cross refer all data to the tube OD, wall thickness and tube sheet thickness.


Consult the link below for the full operating manual and parts list.